4
OPERATION WITH THE REMOTE CONTROL
• The air conditioner will not operate if curtains, doors or other materials block the signal from the remote
control to the indoor appliance.
• Do not expose the remote control to water, direct sunlight or excessive heat.
• Do not allow direct sunlight to fall on the infrared receiver on the indoor appliance as this can impede
the signal from the remote control.
• Remote signal reception is confi rmed with a beep.
Remote Control Specifi cations
Model RG57B/BGEU1
Rated Voltage 3.0V (dry batteries R03/LR03x2)
Signal Receiving Range 8m (26 feet)
Environment -5°C to 60°C (23°F to 140°F)
MODE: Selects mode operation in
the following order:
Auto --> Cool --> Dry --> Heat --> Fan
FAN: Selects fan speed in the
following order:
Auto --> Low --> Med --> High
ON/OFF: Turns the appliance
on or off
SLEEP: Conserves energy
during sleeping hours
TURBO: Starts and stops the
turbo function, which will run
the appliance continuously to
reach the preset temperature in
the shortest amount of time; after
running for 30 minutes turbo
mode will stop
LED: Turns the LED
display on or off
TIMER OFF: Used to set
automatic off function
TIMER ON: Used to set
automatic on function
UP AND DOWN BUTTONS:
Used to increase or decrease
the temperature setting in 1°
increments. Press and hold
the up and down buttons for
three seconds to change the
temperature scale between °C
and °F
DIRECT: Used to change
the louver movement and
set the up or down air fl ow
direction
SWING: Used to start or
stop the horizontal louver
swing feature
SHORTCUT: Used to restore
the current settings or resume
previous settings
OPERATING INSTRUCTIONS
Symbol will fl ash
to indicate that the
appliance has received
the signal from the
remote control.
To Next Page
Loading...
