4
FOR YOUR SAFETY
• Two people should be used when moving the appliance.
• Remove interior and exterior packaging prior to installation.
• Before connecting the appliance to a power source, let it stand upright for approximately 4
hours; this will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Place your appliance on a fl oor that is strong enough to support it when it is fully loaded. To level
your appliance, adjust the front leveling leg at the bottom of the unit.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit to perform improperly.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certifi ed electrician or an
authorized service centre.
• Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
• In order for the cabinet to remain effi cient do not over load it.
• Do not open the door unless necessary.
• Should the appliance be stored without use for long periods, it is suggested, after careful cleaning,
to leave the door ajar. This will allow air to circulate inside the cabinet in order to avoid possible
formations of condensation, mold and odors.
SAVE THESE INSTRUCTIONS!
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Risk of fi re or explosion due to puncturing of refrigerant tubing. Do not use sharp opjects
to aid in defrost. Please handle with care. Keep fl ammable materials and vapors such as
gasoline away from the unit. Use nonfl ammable cleaner.
Disposal of this unit should be in accordance with federal and local regulations.
IMPORTANT WARNING
To Next Page
Loading...
