4
Care and Maintenance
• Turn the temperature control to the “OFF” or “0” position, unplug the unit and remove the food and interior accesso-
ries.
• Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking
soda to a quart of water.
• Wash the baskets and interior accessories with a mild detergent solution.
• The outside of the unit should be cleaned with mild detergent and warm water.
Caution: Failure to unplug the appliance could result in electrical shock or personal injury.
CLEANING THE APPLIANCE
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary - use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free
Number for assistance.
Tel: 1-800-26- (1-800-263-2629)
PROBLEM POSSIBLE CAUSE SOLUTION
Does not work • No power to unit
• Power cord is unplugged
• Wrong voltage is being used
• Check connection of power
cord to power source
• Plug in the unit
• Use proper voltage
Refrigerator runs continuously • Temperature set too low (too
cold)
• Door is not closed
• Hot food inserted
• Door opened too long or too
often
• Close proximity to heat
source or direct sunlight
• Set temperature higher
(warmer)
• Close door securely
• Be sure food is at room tem-
perature before inserting
• Minimize door openings/du-
ration
• Do not place unit close to
heat sources or direct sun-
light
Internal temperature not cold
enough
• No power to unit
• Power cord is unplugged
• Temperature control set too
high (too warm)
• Door is not closed
• Hot food inserted
• Door opened too long or too
often
• Air fl ow obstruction
• Wrong voltage is being used
• Close proximity to heat
source or direct sunlight
• Check connection of power
cord to power source
• Plug in unit
• Check setting and change as
needed
• Close door securely
• Be sure that food is at room
temperature
• Minimize door openings/du-
ration
• Allow room for air to circulate
around the unit
• Use proper voltage
• Do not place unit close to
heat sources or direct sun-
light
To Next Page