Danby DCRM71BLDB - Troubleshooting; Does Not Work; Refrigerator Runs Continuously; Internal Temperature Not Cold Enough

TROUBLESHOOTING
Occasionally, a minor problem may arrise, and a service call may not be necessary- use this troubleshooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby’s Toll Free Number for assistance.
Tel: 1-800-26- (1-800-263-2629)
PROBLEM POSSIBLE CAUSE SOLUTION
1) Does not work.
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being
used.
• Check connection of
power cord to power source.
• Plug in unit.
• Use proper voltage.
2) Refrigerator runs
continuously.
• Temperature set too warm.
• Door is not closed.
• Hot food inserted.
• Door opened too long or
too often.
• Close proximity to heat
source or direct sunlight.
• Lower temperature
control.
• Close door securely.
• Be sure food is at room
temperature before inserting.
• Minimize door
openings/duration.
• Do not place unit close to
heat sources or direct
sunlight.
3) Internal temperature
not cold enough.
• No power to unit.
• Power cord is unplugged.
• Temperature control too
low.
• Door is not closed.
• Hot food inserted.
• Door opened too long or
too often.
• Air flow obstruction.
• Wrong voltage is being
used.
• Close proximity to heat
source or direct sunlight.
• Check connection of
power cord to power source.
• Plug in unit.
• Check setting and increase
as needed.
• Close door securely.
• Be sure that food is at
room temperature.
• Minimize door
openings/duration.
• Allow room for air to
circulate around unit.
• Use proper voltage.
• Do not place unit close to
heat sources or direct
sunlight.
4