Danby DFF1144W - Page 4

Safety Instructions
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electrical shock by providing an
escape wire for the electrical current. This appliance is equipped with
a cord having a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed
and grounded.
WARNING - Improper use of the grounding plug can result if a risk
of electric shock. Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your refrigerator to
extension cords or together with any other appliance in the same wall
outlet. Do not splice the cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous attraction to children.
Remove either the gasket, latches, lids or doors from unused appli-
ances, or take some other action that will guarantee it harmless.
DANGER:Risk of child entrapment. Before you throw away your old
refrigerator or freezer:
« Take off the doors
+ Leave the shelves in place so that children may not eas-
ily climb inside.
DON'T WAIT! DO IT NOW!
Installation
Remove exterior and interior packings, wipe the outside
thoroughly with a soft dry cloth and the inside with a wet,
lukewarm cloth. Avoid placing the cabinet in a narrow
recess or near any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep the rear of
the refrigerator 5 inches away from the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the
refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect
the acrylic coating. Heat sources nearby will cause
higher electricity consumption.
DFF1144W
The refrigerating system in this refrigerator is a “Frost Free”
system. This type of system requires no user intervention
(i.e. defrosting) other than selecting required cooling
temperatures and the usual care and maintenance.
To avoid vibration, the cabinet must be set level. This is
accomplished by adjusting the (2) front leveling legs locatec
under the refrigerator cabinet. To start the refrigerator, tu
the temperature control (1-max) to the position
corresponding to the desired cooling.
The refrigerator temperature will vary depending on the
quantity of the food stored and on the frequency with which
the door
is opened.
1. THERMOSTAT DIAL: For controlling the temperature
inside the refrigerator/freezer. Turns the motor on as
soon as the temperature rises above the desired level.
2. SEPARATE FREEZER SECTION: holds ice cube tray
and storage for frozen food.
3. ICE CUBE TRAY: Ice cubes are easily removed from |
the tray. (Not shown)
4. PLASTIC COATED SHELVES: Odor resistant,
rustproof, and removable for easy cleaning.
5. MAGNETIC GASKET: Tight fitting door seal keeps a
the cooling power locked inside. No hooks or latches.
6. CRISPER WITH TEMPERED-GLASS SHELF: Easy ©
interior viewing. l
7. CANSTOR™ DOOR LINER: Holds 355 mL cans of po
juice, or beer.
8. GALLON DOOR STORAGE: can be adjusted to hold
smaller items with slide in rail.
9. 2 LITER TALL BOTTLE STORAGE: holds 2 liter bottle