EasyManua.ls Logo

Danby DKC054A1BSL2DB - Troubleshooting Common Issues; Unit Malfunctions and Frequent Cycling; Noise, Vibrations, and Door Closure Problems; Beer Dispensing Flow and Foam Issues

Danby DKC054A1BSL2DB
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PROBLEM POSSIBLE CAUSE
The unit does not operate • Not plugged in
• The circuit breaker tripped or blown fuse
Turns on and off
frequently
• The room temperature is hotter than normal
• The door is open too often
• The door is not closed completely
• The temperature control is not set correctly
• The door gasket does not seal properly
• The unit does not have proper clearance
Vibrations • Check that the keg cooler is level
The keg cooler seems to
make too much noise
• The rattling noise may come from the fl ow of refrigerant, which is
normal
• Gurgling, caused by liquid refrigerant cycling is normal
• Contraction and expansion of the inside walls may cause popping
and crackling noises
• The keg cooler is not level
The door will not close
properly
• The keg cooler is not level
• The door was reversed and not properly reinstalled
• The gasket is dirty
• The shelves or stand are out of position
• The keg is not properly centered in the unit
• The casters are not attached
Excessive beer foam • Ensure the beer line hose from the tower and the CO
2
air line hose
from the CO
2
regulator are attached to the correct connections on
the coupler; beer line to the top of the coupler, CO
2
air line to the
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
2
connection at the coupler
has a hole in it
• The CO
2
pressure may be set too high; try turning the pressure
down
• Ensure that the valve spool plastic rod is inserted into the coupler
Weak beer fl ow • Ensure the beer line hose from the tower and the CO
2
air line hose
from the CO
2
regulator are attached to the correct connections on
the coupler; beer line to the top of the coupler, CO
2
air line to the
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
2
connection at the coupler
has a hole in it
• The CO
2
pressure may be set too low; try turning the pressure up
• Ensure there are no bends or kinks in any of the hoses that could
impede fl ow
15
Troubleshooting
Danby Consumer Care: 1-800-263-2629
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time

Other manuals for Danby DKC054A1BSL2DB

Related product manuals