EasyManua.ls Logo

Danby DPF073C1WDB - Troubleshooting

Danby DPF073C1WDB
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free
Number for assistance.
Tel: 1-800-26- (1-800-263-2629)
PROBLEM POSSIBLE CAUSE SOLUTION
Does not work • No power to unit
• Power cord is unplugged
• Wrong voltage is being used
• Check connection of power
cord to power source
• Plug in the unit
• Use proper voltage
Refrigerator runs continuously • Temperature setting is too
cold
• Door is not closed
• Hot food inserted
• Door opened too long or too
often
• Close proximity to heat
source or direct sunlight
• Set temperature to a warmer
setting
• Close door securely
• Be sure food is at room tem-
perature before inserting
• Minimize door openings/du-
ration
• Do not place unit close to
heat sources or direct sun-
light
Internal temperature not cold
enough
• No power to unit
• Power cord is unplugged
• Temperature control set too
high (too warm)
• Door is not closed
• Hot food inserted
• Door opened too long or too
often
• Air fl ow obstruction
• Wrong voltage is being used
• Close proximity to heat
source or direct sunlight
• Check connection of power
cord to power source
• Plug in unit
• Check setting and increase
(make cooler) as needed
• Close door securely
• Be sure that food is at room
temperature
• Minimize door openings/du-
ration
• Allow room for air to circulate
around the unit
• Use proper voltage
• Do not place unit close to
heat sources or direct sun-
light
Internal temperature too cold • Temperature control set too
cold
• Adjust settings as needed
Freezer not cold enough • Temperature control too warm
• Door not closed
• Hot food inserted
• Doors open too long/often
• Wrong voltage being used
• Adjust settings as needed
• Close door securely
• Cool food before inserting
• Minimize door openings/du-
ration
• Use proper voltage
Light will not work • No power to unit
• Power cord is unplugged
• Bulb is loose/needs replacing
• Door switch is stuck
• Check connection of power
cord to power source
• Plug in unit
• Tighten or replace bulb
• Check the switch for obstruc-
tions, clean if necessary
10