Danby DUF138E1 - Levelling Legs; Decorative Cover

Installation Instructions
If the unit is not level, the doors and seal may not function correctly, causing the
unit to operate ineffi ciently. To level the unit turn the levelling leg(s) clockwise to
rise or counter-clockwise to lower.
LEVELLING LEGS
To install the decorative cover, please follow the steps in the below diagram. The decorative cover is installed at the bot-
tom of the unit.
DECORATIVE COVER
ķ
ĸ
The unit must be unplugged before installing the handle.
1. Take 2 screws and install them in the pre-drilled door holes, be
sure to turn them until they cannot be further tightened.
2. Position the handle over the screws.
3. Put the other set of handle screws in the hole on the side of the
handle and turn until they are fully tightened.
HANDLE INSTALLTION
ķ
ķ
ĸ
ĸ
Ĺ
Ĺ
5