17
TROUBLE SHOOTING
Notice
• Do not operate the washer when the water
pressure is lower than 0.02MPa or higher than
0.8MPa to avoid damage of the inlet system
• Do not use the washtub as a water container and
always to drain water completely
• Close the tap after use
• Unplug the power cord
Location to be checked
• Is the drain hose kinked or hung too high?
• Is the drain hose frozen or clogged?
• Is the laundry unevenly balanced in the tub?
• Is the lid closed?
• Is the washer on a level surface?
• Is the water faucet open?
• Is the water pressure too low?
• Is the filter in the inlet valve clogged?
• Is there any water?
• Is the power cord firmly plugged in?
• Have you blown a fuse or tripped the breaker switch?
• Did the water reach the program level?
Problem
The washer will not
drain
Spin malfunction
Washer will not fill up
Spin malfunction
WIRING DIAGRAM
To Next Page
