Need help?Do you have a question about the D&H PD10MU and is the answer not in the manual?
Product is not suitable for children under 14 years old.
Risk of injury from sharp edges and points during improper use.
Technical specifications of the PD10MU decoder, including dimensions and load capacity.
Details on wired and plug-in connection methods for the decoder.
Key features for DCC operation, including speed steps and load regulation.
Information on updating the decoder's firmware via digital center or programmer.
Essential checks for locomotive condition and run-in before installation.
Instructions to disconnect motor connections from ground and chassis.
List of functions supported in DCC mode, covering addresses and speed steps.
Guidance on configuring decoder features using Configuration Variables (CVs).
Table showing output value assignments for functions like shunting gear and lights.
Details on configuring timer functions for outputs, including off and timed activation.
Explanation of electric couplings as inductive components needing protection.
Importance of freewheeling diodes to prevent damage from inductive loads.
Instructions for configuring braking methods and ramps using CV parameters.
Guidance on fine-tuning braking distance and managing reverse direction.
General| Model | PD10MU |
|---|---|
| Category | Media Converter |
| Data Transfer Rate | 10/100Mbps |
| Fiber Type | Multi-mode |
| Connector Type | SC |
| Wavelength | 1310nm |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Interface | RJ45 |
| Power Supply | 5V DC |
To Next Page
