1.7 RECOMMENDATIONS
1. WHEN OPERATING RIG, WEAR ADEQUATE SAFETY CLOTHING.
2. DO NOT CRANK THE ENGINE FOR MORE THAN 30 SECONDS.
ALLOW THE ELECTRIC STARTING MOTOR TO COOL FOR TWO
MINUTES BEFORE CRANKING THE ENGINE AGAIN.
3. ALWAYS CLOSE JACK ISOLATING VALVES BEFORE STARTING
UP.
4. ALWAYS CHECK ALL CONTROLS ARE IN NEUTRAL WHEN
STARTING UP.
5. FIT MAST LOCATION LOCKING/LOCATION PINS BEFORE
DRILLING.
6. ALWAYS INSURE HANDBRAKE IS ON BEFORE RAISING
LEVELLING RAMS.
7. ALWAYS HAVE ALL JACKS IN CONTACT WITH GROUND
BEFORE RAISING MAST.
8. ATTEMPT AT ALL TIMES TO ENSURE PERFECTLY CLEAN
HYDRAULIC OIL IS MAINTAINED.
9. WASH OFF, AS SOON AS POSSIBLE, ANY HYDRAULIC OIL THAT
GETS INTO CONTACT WITH SKIN.
10. INSPECT WIRELINES AND HOSES FOR WEAR DAILY.
11. ALWAYS REPLACE WIRELINES AT THE FIRST SIGN OF WEAR.
THE SIGNS OF WEAR ARE FLATTENING, OR BROKEN
STRANDS.
To Next Page
Loading...