38
PROBLEM CAUSE SOLUTION
The cylinder does not move
Mechanical impediment Remove the obstacle
Cylinder or gasket damaged
Check and replace if
necessary
Joint and or hydraulic pump
failure
Check and replace if
necessary
Hydraulic piping failure
Check and replace if
necessary
Distributor pressure too low
Check and restore if
necessary
The machine does not move
in either driving direction,
even if the levers are moved
Hydraulic pipe broken
between hydraulic motor and
pump
Check and replace if
necessary
Pump and/or hydraulic motor
damaged
Contact an authorized
workshop
Problem in the translation
system (the machine does
not move or steer)
Hydraulic oil overheated
Wait until the hydraulic oil
cools, then try again
Even if the lever is moved,
the corresponding track
does not move
Hydraulic pump failure
Contact an authorized
workshop
Hydraulic piping failure
Check and replace if
necessary
Hydraulic oil overheated Low hydraulic oil level Check and restore if
necessary
For checks of the diesel engine, follow what is mentioned in relevant user’s manual
supplied with the machine.
To Next Page
Loading...