Danelec DM800 ECDIS G2

Need help?

Do you have a question about the Danelec DM800 ECDIS G2 and is the answer not in the manual?

Summary

Scope and Purpose

References

Lists all external documents and manuals referenced within the installation guide.

Terms and Abbreviations

Defines key terminology and acronyms used throughout the DM800 ECDIS G2 manual.

System Overview

DM800 ECDIS G2 Components

Details the main hardware components of the DM800 ECDIS G2 system.

Installation

List of Parts

Provides a comprehensive list of all components required for system installation.

Installation Kit Contents

Describes the specific items included in the ECDIS installation kit.

Power and Grounding Requirements

Explains essential electrical supply and grounding procedures for safe installation.

Wago Connector Tool

Details the function and use of the tool for opening Wago wire clamps.

Termination Resistors

Explains the configuration and use of termination resistors for IEC 61162-2.

Recommended Standard Configuration

System Configuration

ECDIS System Power Up

Step-by-step guide on connecting power and initiating the ECDIS system.

Initial System Configuration Steps

Guides through the wizard for initial setup of monitor, cluster, and ports.

Finalizing Configuration and USB Key Setup

Completes system setup, remote port configuration, and USB key management.

ECDIS Software Configuration

Main Screen and Menu Navigation

Overview of the ECDIS main screen interface and menu access.

Service Technician Access

Instructions on how to access protected system settings using a password.

Sensor Management

Procedures for adding, configuring, monitoring, and deleting sensors.

Vessel Particulars Setup

Configuration of vessel dimensions, performance, and static data.

Initial Data and Chart Installation

Guides for performing initial chart data and permit installation.

Advanced Configuration

External Network Configuration

Setting up IP addresses for access to external data networks.

External Equipment Setup

Configuring VDR image output and NavBox chart updates.

Virtual Data Lines via TCP;IP

Establishing TCP/IP client or server connections for data transfer.

Service Menu

Service Panel Functions

Details the various tools and options available within the service panel.

DPU Replacement and Support Dumps

Procedures for replacing DPU hardware and generating support data dumps.

Re-installation of ECDIS

ECDIS Software Installation Process

Step-by-step instructions for performing a complete re-installation of the ECDIS software.

IEC 61162-450 Interface Specifications

Data Rate, Datagram Size, and Parameters

Technical specifications for data rate, datagram size, and default parameters.

Other Network Functions (ONF)

Details on NavBox interface, TCP IEC61162-1 data, and internal IP addresses.

Interface, Connector, and Cable Specifications

Specifies requirements for network interfaces, connectors, and cables.

Installation Plan

Commissioning

Maintenance Schedule

List of Spare Parts

Appendix A: Main Unit Installation Drawing

Appendix B: EK 03-001 Keyboard Drawings

Appendix C: Cortron Keyboard Drawings

Appendix D: Alarm Panel Installation Drawings