Danfoss EvaKool SupaKool User Manual

Instruction Manual
14 |
P a g e
7. Error Codes
The error codes are depicted by a number of flashes by the error light in a sequence every
four seconds.
Code
Reason Solution
1 Flash
Low Voltage
- Please check the source
voltage to ensure it is above
the cut out. Try lowering the
voltage cut out setting to
LOW.
- The vehicle cabling may be
inadequate/unsuitable,
please refer to cable
specifications table for
correct cable thickness
(Page 2)
- Try on a different power
source
2 Flashes
Fan issue
- Fan is drawing too many
Amps (Over 1 Amp) –
Contact Evakool
3 Flashes
Compressor Start Issues
- Unplug for 10 Minutes
- Try on a different power
source.
- Possible Electronic Box or
compressor fault – contact
Evakool
4 Flashes
The compressor speed is too low
- Unplug for 10 Minutes
- Reduce product load inside
unit
- Move unit to a lower
ambient temperature
- Clean vents / ensure clear
air flow over compressor
5 Flashes
Ambient Temperature too high
- Clean vents / ensure clear
air flow
- Fan Fault – Contact
Evakool

Danfoss EvaKool SupaKool Specifications

General

Brand	Danfoss
Model	EvaKool SupaKool
Category	Refrigerator
Language	English