2
Touching the electrical parts may be fatal — even after
the equipment has been disconnected from the AC line.
To be sure that the capacitors have fully discharged,
wait 15 minutes after power has been removed before
touching any internal component
DANGE
!
Because the drive uses large electrolytic capacitors in its power circuitry, it can maintain a
dangerous voltage level for up to 15 minutes after power has been removed. Therefore,
always be sure that power has been removed from the drive for at least 15 minutes before
working with the power circuitry of the drive.
It is always wise to use a voltmeter to measure any potentially dangerous electrical circuit
before working on it.
To Next Page
Loading...
