Danieli Automation ID2202 User Manual

Danieli Automation – ID2202
30
The following table summarises the signals of the rear LED.
Suggestions Verify / improve the proper sighting and/or installation Material is too cold or selection of sensitivity is inadequate Analyse what causes the overheating: - exposure to sources of heat - excessive ambient temperature
Output status MATP = OFF HEALTHY = ON (if photocell switched on) MATP = OFF HEALTHY = OFF MATP = ON HEALTHY = OFF MATP = ON HEALTHY = ON MATP = ON/OFF according to the presence or not of material HEALTHY = OFF
Description ABSENCE OF MATERIAL, or photocell switched off RELIABLE DETECTION (if photocell switched on) ABSENCE OF MATERIAL Signal near the threshold of presence of material (anyway below the threshold) The LED flashes more and more frequently as the signal approaches the threshold PRESENCE OF MATERIAL Signal near the threshold of presence of material (anyway above the threshold) The LED flashes more and more frequently as the signal approaches the threshold Detection is NOT RELIABLE PRESENCE OF MATERIAL Signal beyond the threshold of presence of material. Detection is reliable OVERHEATING
The photocell can keep operating normally.
Rear LED status GREEN LED = OFF RED LED = OFF GREEN LED = OFF RED LED = Short pulses GREEN LED = ON RED LED = Short pulses GREEN LED = ON RED LED = OFF GREEN LED = OFF RED LED = 1Hz Flashes
Danieli Automation Standard - Installation Use and Maintenance Manual - ID2202
Certified by OneDoc A.620.107 Rev.04-MU 31/145 #1061394

Danieli Automation ID2202 Specifications

General

Brand	Danieli Automation
Model	ID2202
Category	Security Sensors
Language	English