Danmeter elpha ii 1000 - Get Started

3
Get Started
ELPHA II 1000 has 2 output channels; channel A and B. Both channels are operated alike.
1. Retract the sliding lid. Insert the battery and replace the
lid.
2. Connect the lead wires to the output channels on the
device.
3. Connect the lead wires to the electrodes.
4. Clean the skin. Remove the plastic cover from the
electrodes before attaching to the skin. The electrodes
must not touch each other.
5. Turn on the ELPHA II 3000 by pressing the blue on/off
button.
6. Choose programme and adjust the stimulation level.
When the keyboard lock symbol appears
, turn
down the level to allow further adjustment of the
required stimulation level.
7. The stimulation automatically stops when treatment
time expires.
-
+