Manual. D2-10A and D2-10C Two-Post Lift, Installation and Operation Manual, Manual Part Number 5900249,
Manual Revision B, released February 2021.
Copyright. Copyright © 2021 by Dannmar BendPak Inc. All rights reserved. You may make copies of this
document if you agree that: full attribution goes to BendPak Inc., you are not authorized to make changes to the
content, you do not gain any rights to this content, and you will not use the copies for commercial purposes.
Trademarks. BendPak, the BendPak logo, Dannmar, and the Dannmar logo are registered trademarks of
BendPak Inc. All other company, product, and service names are used for identification only. All trademarks and
registered trademarks mentioned in this manual are the property of their respective owners.
Limitations. Every effort has been made to ensure complete and accurate instructions are included in this
manual. However, product updates, revisions, and/or changes may have occurred since this manual was
published. BendPak reserves the right to change any information in this manual without incurring any obligation for
equipment previously or subsequently sold. BendPak Dannmar is not responsible for typographical errors in this
manual. You can always find the latest version of the manual for your product on the Dannmar website.
Warranty. The BendPak warranty is more than a commitment to you; it is also a commitment to the value of
your new product. Contact your nearest Dannmar BendPak dealer or visit www.dannmar.com/support/ for
full warranty details. Be sure to register your warranty with Dannmar.
Safety. Your Lift was designed and manufactured with safety in mind. Your safety also depends on proper
training and thoughtful operation. Do not set up, operate, maintain, or repair the Lift without reading and
understanding this manual and the labels on the unit;
do not use your Lift unless you can do so safely!
Owner Responsibility. In order to maintain your product properly and to ensure operator safety, it is the
responsibility of the product owner to read and follow these instructions:
• Follow all installation, operation, and maintenance instructions.
• Make sure product installation conforms to all applicable local, state, and federal codes, rules, and regulations,
such as state and federal OSHA regulations and electrical codes.
• Read and follow all safety instructions. Keep them readily available for operators.
• Make sure all operators are properly trained, know how to safely operate the unit, and are properly supervised.
• Do not operate the product until you are certain all parts are in place and operating correctly.
• Carefully inspect the product on a regular basis and perform all maintenance as required.
• Service and maintain the unit only with approved replacement parts.
• Keep the manual with the product and make sure all labels are clean and visible.
Only use the Lift if it can be used safely!
Enter the Model Number, Serial
, and the Date of Manufacture from the ID label
. This information is required for part or
:
To Next Page
Loading...
