Need help?Do you have a question about the Dante BEATRICE Series and is the answer not in the manual?
General| Brand | Dante |
|---|---|
| Model | BEATRICE Series |
| Category | Intercom System |
| Language | English |
Manufacturer's declaration of conformity to EU harmonization legislation.
Restriction of hazardous substances in electrical and electronic equipment.
UK regulations for waste electrical and electronic equipment.
Description of front panel controls and indicators including Talk switch and LEDs.
Description of rear panel connectors for network and headset.
Description of the side panel external control input connector.
How to enter and navigate configuration modes for device settings.
Details on adjusting mic gain, phantom power, sidetone, headphone levels, and party mode.
Procedure for sending and receiving calls between Beatrice units.
Analogue representation of audio signal flow within the device.
Download and install the Dante controller software from Audinate.
Connecting Beatrice units to the network and network considerations.
Running Dante Controller, device naming, and troubleshooting connection issues.
Activating AES67 support via the Dante Controller.
Sending, receiving, and restrictions for AES67 audio flows.
Step-by-step guide to update device firmware using DfuSe Demo.
Procedures for checking and updating the Ultimo Chipset firmware.
Pin configuration for 5-pin XLR connectors.
Pin configuration for 4-pin XLR connectors.
To Next Page