Dantel PointMaster TL1 User Manual

Copyright 2000 by Dantel, Inc. • Dantel is a registered trademark of Dantel, Inc. • ISO 9001 Registered
Printed in the U.S.A.
CAUTION
• Install or remove modules from the shelf only when the power is off.
If you install a module in the shelf with the power on, the internal
circuitry may suffer damage and the product warranty will be void.
• Remove and install circuit boards only in a static-safe environment
(use antistatic wrist straps, smocks, footwear, etc.).
• Keep circuit boards in their antistatic bags when they are not in use.
• Do not ship or store circuit boards near strong electrostatic, electromag-
netic, magnetic, or radioactive fields.
• For more complete information on electrostatic discharge safety
precautions, refer to Bellcore
TM
Technical Reference # TR-NWT-000870.
INSTALLATION & OPERATION MANUAL
46310-IG-0300 <90-00226>
About this Practice:
This is a new document.
• The procedure described in this
document requires the use of the
TL1 PointMaster practice as well.
Issue date: March 2000
Reissued Practices: Updated and
new content can be identified by a
banner in the outside margin.
UPDATED
Table of Contents
Introduction .......................................................................................... 2
Installation............................................................................................ 2
Warranty ............................................................................................... 8
TL1 POINTMASTER
INSTALLATION GUIDE
PointMaster
CPU/Alarm
TXD Mstr
RXD Mstr
TXD Exp.
RXD Exp.
Fuse
Low Batt
NEBS
Certified


Dantel PointMaster TL1 Specifications

General

Brand	Dantel
Model	PointMaster TL1
Category	Controller
Language	English

Summary

Introduction

Installation

General Safety Precautions

Critical safety warnings for module installation and handling circuit boards.

Load TL1 PointMaster Editor

Step-by-step guide to installing the TL1 PointMaster Editor software on your computer.

Configure Hardware and ESD Precautions

Steps for setting hardware switches/straps and essential ESD handling precautions.

Status Check

Procedures to verify the operational status of the PointMaster unit after installation.

Database Configuration

Guide to setting up the PointMaster database via the TL1 Editor.

Master Port Configuration

Steps to configure the TL1 Master Port communication parameters.

System Configuration

Instructions for adjusting PointMaster time, date, and password settings.

TL1 Editor Database Operations

Procedures for managing database files within the TL1 Editor software.

Final Steps and Verification

Completing the installation, performing final checks, and verifying alarms.

Warranty

Limited Warranty Terms

Details of the standard hardware and software warranty provided by the seller.

Troubleshooting and Support

Guidance for resolving issues, contacting technical support, and RMA process.