Danze D308340 - User Manual

To Next Page

Tools You Will Need

Herramientas Necesarias

Outils dont vous aurez besoin

Before Your Installation

Antes de Instalar

Avant l’installation

D308340

Two Handle Lavatory Faucet

Grifo De Baño Con Dos Manijas

Robinet De Lavabo À Poignées Double

Check with the local plumbing code requirements before installation.

Antes de la instalación, consulte las exigencias del código local de

plomería.

Vérifier les exigences du code de la plomberie qui s’applique avant

de procéder à l’installation.

This product is engineered to meet the EPA watersense flow requirements.

The flow rate is governed by the aerator. If replacement is ever required,

be sure to request watersense compliant lavatory faucet aerator to retain

the water conserving faucets of this product.

Este producto se ha hecho para cumplir con las exigencias de caudal

Water Sense de la EPA. El caudal está controlado por el aireador. Si es

necesario efectuar una sustitución, solicite un aireador del grifo del

lavabo que cumpla con el programa WaterSense para mantener los

grifos que conservan agua de este producto.

Ce produit a été conçu pour répondre aux exigences de débit du

programme Watersense de l’EPA. Le débit est réglé par un aérateur.

Si jamais il doit être remplacé, s’assurer de demander un aérateur

de robinet de salle de bains conforme au programme Watersense

pour continuer d’économiser l’eau.

Check to make sure you have the following parts indicated below:

Verifique que tenga todas las partes indicadas:

Vérifier pour vous assurer que vous possédez les pièces au bas:

Need Help? Please call our toll-free Customer service line at 1-888-328-2383 or WWW.DANZE.COM for additional assistance or service.

Requiere asistencia? Favor llamar a nuestro servicio a clientes sin costo al 1-888-328-2383 o WWW.DANZE.COM para asistencia adicional o servicio.

Besoin d’aide? Veuillez communiquer avec notre service à la clientèle au numéro sans frais 1-888-328-2383 ou WWW.DANZE.COM pour obtenir du

service ou de l’aide additionnels.

Need help?

Do you have a question about the Danze D308340 and is the answer not in the manual?

This document describes the Danze D308340 Two Handle Lavatory Faucet, providing installation instructions, troubleshooting tips, and a parts list.

Function Description:

The Danze D303840 is a two-handle lavatory faucet designed for use in bathrooms. It allows for the control of water flow and temperature through two separate handles. The faucet is engineered to meet EPA WaterSense flow requirements, ensuring water conservation. The flow rate is regulated by an aerator, which should be replaced with a WaterSense compliant aerator if necessary to maintain the product's water-conserving features. The faucet also includes a pop-up drain assembly for controlling the basin's drainage.

Important Technical Specifications:

Model Number: D303840
Type: Two Handle Lavatory Faucet
Water Conservation: EPA WaterSense compliant. The flow rate is governed by the aerator.
Mounting: Designed for deck-mounted installation, typically through a 1-1/2" diameter mounting hole.
Connections: Standard hot and cold water supply lines.
Drain Type: Pop-up drain assembly.

Usage Features:

Two-Handle Operation: Separate handles for hot and cold water allow for precise control over water temperature and flow.
WaterSense Compliance: The faucet is designed to conserve water without sacrificing performance, making it an environmentally friendly choice.
Pop-Up Drain: An integrated pop-up drain mechanism allows for easy opening and closing of the sink drain.
Installation: The manual provides detailed, step-by-step instructions for both faucet and pop-up drain installation, including diagrams.
- Faucet Installation Steps:
  1. Apply silicone sealant around the spout mounting ring and insert the spout into the mounting hole.
  2. From underneath the sink, install the rubber washer, metal washer, lock nut, and adapter.
  3. Remove mounting hardware from the hot/cold valves and attach water supply to the valve body.
  4. Place the handle body through the left hole and reassemble the mounting hardware.
  5. Connect hoses from the valves to the adapter on the spout.
  6. Apply pipe tape on the thread of the inlet port.
  7. Attach water supply hoses or tubes to the faucet, ensuring to avoid twisting the copper tube from the faucet.
  8. After installation, remove the aerator (14), open the hot and cold water supplies for one minute to flush debris, then close the handles and re-assemble the aerator.
- Pop-Up Drain Installation Steps:
  1. Remove the old drain assembly and clean sink surfaces.
  2. Place a ring of silicone sealant around the drain opening.
  3. Insert the threaded end of the drain body up through the drain hole and attach the flange (9) to the body.
  4. Thread the lock nut (11) from the underside of the sink until the rubber washer sits securely, then tighten the lock nut.
  5. Insert the stopper assembly (8) into the drain, and the ball rod (5) into the rod port and the hole at the bottom of the stopper assembly.
  6. Place one end of the spring clip (4) on the ball rod (5), pass the tip of the rod through the hole in the lift rod strap (3), and then through the hole on the other end of the spring clip (4).
  7. Insert the bottom of the lift rod (1) into the hole at the top of the lift rod strap (3) and tighten with the thumb screw (2).
Troubleshooting Guide: The manual includes a section to address common issues:
- Leaks underneath handle: Caused by a loose retainer nut (8). Action: Tighten the retainer nut (8).
- Aerator (14) leaks or has an inconsistent water flow pattern: Caused by a dirty or misfitted aerator. Action: Unscrew the aerator (14) to check rubber packing or replace the aerator.
Required Tools:
- Adjustable wrench
- Pipe tape
- Groove joint plier
- Phillips screwdriver
- Silicone sealant

Maintenance Features:

Durability: The faucet is designed for years of trouble-free performance.
Cleaning: To maintain its appearance, the faucet should be cleaned periodically with a soft cloth.
Caution: Avoid abrasive cleaners, steel wool, and harsh chemicals, as these can dull the finish and void the warranty.
Parts List: A comprehensive list of replacement parts is provided with corresponding numbers and descriptions, facilitating future repairs or replacements. Key components include:
- Handle Cap/Tapón/Capuchon de la manette (1)
- Handle Body/Cuerpo de manija/Corps de manette (3)
- Cartridge Disc Ceramic-Hot/Cartucho de disco cerámico-caliente/Cartouche à disque en céramique-chaud (9-A)
- Cartridge Disc Ceramic-Cold/Cartucho de disco cerámico-frío/Cartouche à disque en céramique-froid (9-B)
- Aerator/Aireador/Aérateur (14)
- Pop-Up Body/Desagüe levadizo y tubo de desagüe/Vidange mécanique et tuyau de queue (29)
- Stopper Assembly/Ensamblaje de parador/Assemblage de bouchon (30)
- Lift Rod/Varilla de elevación/Tige de levage (23)

Customer Support:

For additional assistance or service, customers can contact Danze's toll-free customer service line at 1-888-328-2383 or visit their website at WWW.DANZE.COM.

Danze D308340 Specifications

General

Brand	Danze
Model	D308340
Category	Kitchen & Bath Fixtures
Language	English

Related product manuals