Need help?Do you have a question about the DARCHE DUSK TO DAWN+ and is the answer not in the manual?
General| Light Source | LED |
|---|---|
| Charging Method | USB |
| Material | Polyester |
| Waterproof Rating | 2000mm |
| Features | Built-in LED lighting |
| Battery Type | Lithium |
| Battery Life | Up to 12 hours |
| Light Modes | Low, Medium, High |
Assemble the two composite poles by joining end and middle sections with aluminum sleeves.
Feed the assembled pole through the swag's top sleeve and insert into the base pin.
Ensure pole sleeve is centered before pushing upward to insert the second pin.
Clip the swag to the composite poles, alternating sides for even tension.
Stretch the swag base and insert the spreader pole into the center eyelet.
Extend the spreader pole, insert into the eyelet, and tension to shape the swag.
Partially close zips, release spreader pole, and unclip composite poles.
Fold canvas, roll tightly, and secure with compression straps.
Soak and dry the swag 2-3 times to swell canvas and seal stitching for weather protection.
Use soft brush and cold water; dry completely; store off concrete in a dry spot.
Open window slightly on cold nights to allow airflow and minimize condensation.
To Next Page