DARCHE DUSK TO DAWN+ - Setting Up Your DARCHE Swag; Assemble Composite Poles; Insert Pole into Swag Sleeve

2
DARCHE.COM.AU
INSTRUCTION MANUAL
Step 1
Unroll the swag onto a flat, well-drained area free of sharp objects that may penetrate the swags PVC floor.
Assemble the two composite poles.
Step 2
Feed the pole through the sleeve on the top of the swag and insert it into one of the pins.
DUSK TO DAWN
CONTENTS
• 1 x Dusk to Dawn+ swag
• 1 x Composite swag pole pack (6 sections that make up 2 poles)
• 1 x Trigger lock spreader pole
• 1 x 70mm high-density foam mattress
• 8 x Pegs
• 2 x Guy ropes
• 1 x Canvas carry bag
PLEASE NOTE
Prior to first use of the Dusk to Dawn+ swag, it is important to remove the mattress from its compression sleeve and
allow it to expand.
Seasoning the swag is not essential but is recommended. For full instructions on seasoning your DARCHE swag, see
How to Season Your Swag (page 7).
SCAN TO WATCH
THE VIDEO
Remove the first pole bundle (3x pole sections) from
the pack:
• 2x END section poles (aluminium sleeve on one
endof the pole).
• 1 x MIDDLE section pole (aluminium sleeves on
both ends of the pole)
Assemble the END section poles into each side of the
MIDDLE section pole sleeves, so all 3 sections are
joined to form one pole. Each end of the pole will have
the aluminium sleeve to insert the base pin.