7
We advise you to read the instruction booklet carefully, quietly and completely
before you begin cycling. Furthermore we advise you to check all parts before
you start using the cycle. Do not remove any parts. For maintenance please contact your
dealer. The dealer has all the information and skill to keep your bike on the road.
To adjust the handlebar, the handlebar stem adjuster must be lifted. This is done
by pushing the small slide up. Make sure that the handlebar is straight.
In order to adjust the tension of the quick release, turn the adjusting screw, as shown above.
Make sure that the safety mark is not exposed,
To adjust the handlebar height, use a hex key. The recommended torque is 22-25 Nm)
Riding your e-bike:
Adjusting the handlebar
It is best to shift back to gear 1 or 2 in
the low support mode (Eco). Once
you reach the desired speed, select
the support which ts your speed.
The design of the cycle is a combination of ergonomics, technology and aestheics, which
results in a unique cycling experience. The smart design, together with the chosen parts,
gives a safe cycling experience. The frame is made of aluminum (6061), it is light, but stiff
and sturdy for pleasant cycling. The top speed conforms to national legislation. The support
works up to a maximum of 25 km/h. (under normal circumstances, for a rider weighing 80
kg)
To Next Page
Loading...
