Controls
Blend: Mixes the clean input signal with the overdriven signal.
The clean signal remains at unity gain while the volume of the
overdriven signal is set by the Level knob, allowing for fine
control of the blend ratio.
Tone: Controls the high frequency content of the sound. A
variable low pass filter from 3kHz (ccw) to 8kHz (cw)
Level: Sets the volume of the overdriven signal.
Drive: Sets the amount of saturation in the overdriven signal.
Grunt: When engaged provides a massive low end boost to
really thicken your sound.
Mid Boost: Gives a subtle 6dB boost from 300 Hz to 1kHz to
help you cut through a bit more.
Technical Specifications
Input Impedance 500k
Output Impedance 1k
Current Consumption ~17mA
Voltage 9V DC (Center Negative)
Dimensions
Width 75 mm (2.95 in)
Height 111 mm (4.37 in)
Depth 45 mm (1,77 in)
To Next Page
Loading...