DARLEY ZSP - Page 3

Prepared by: RJG Rev. A
Approved by: WAH Date: 03/16/12
Revised by: WAH Via ECO 11337 Rev. Date: 02/19/2016
1200643.doc
Table of Contents
Type ZSP Fire Pump
ALL DOCUMENTS ARE FOUND IN THIS MANUAL IN THE
ORDER THEY ARE LISTED (left to right and top to bottom)
Safety -------------------------------------------------------------------------------------------------------- 1200643
SECTION 1 – Definition of Symbols and Immediate Safety Information
Safety Symbol Definitions and Immediate Safety Information ---------------------------- 1200643
SECTION 2 – General Information and Operations
General Operation --------------------------------------------------------- Recommendations – 1200514
PTO Pump Shift – 1200591, 1200590
General Operations Info - 1200509
Definitions, Operating Characteristics of Pumps, and Conversion Factors - 1200510
NFPA 1901 Test Table - 1201500
Discharge Tables - 1201501
Reach and Friction Loss Tables – 1201502
SECTION 3 – Installation
Installation ------------------------------------------------------------------------------------------------- 1201050
Driveline Guideline Drawing – DGM1301
ZSP Suction Pipe Mounting Bracket Detail – DGM2902
Suction Mounting Bracket Pivot Detail – DGM1302
ZSP Standard Transmission Mounting Bracket Detail – DGM2908
Vibration isolating mounting bracket assembly for the pump’s suction head – DGM2905
Vibration isolating mounting bracket assembly for the pump’s gearbox – DGM2906
Mounting Bracket – 4042200
Mounting Rubber Isolator – 4421804
Mounting Isolator Snubbing Washer – 3603931
Pump Heater Core Plumbing Detail – DGS0400
PTO Pump Engagement Electrical Schematic – DGS1100
ZSP Installation Manual Appendix SPICER DRIVELINE GUIDE J3311-1-DSSP – 1201026
SECTION 4 – Pump Detail
Description, Operation & Maintenance, & Lubrication --------------------------------------- 1200643
Related Drawings --------------------------- Pump Cross Section & Explode Drawing – DZC0006
Trans. Cross Section & Explode Drawing – DZC0019 & DZC0020
Pump & Trans. Dimensional Drawings – DZD0034, DZD0035, DZD0036 & DZD0037
Mechanical Seal ------------------------------------------------------------------------------------------ 1200583
Seal Installation Instruction – 1201040