P01: Backlight. Range 1-3, 3 = Brightest
P02: Units. 1 = KPH, 2= MPH
P03: Battery Voltage. 24, 36, 48, 52, 60.
Default = 48V
P04: Dash Timeout. Range 1-60 minutes
Default = 10 minutes
P06: Tire Diameter. Default = 8.5
P07: Motor Poles. Default = 28
P08: Speed Limiting. Default = 50
P09: Start Method. Default = 0, instant
1 = Push start
P10: Reserved. Default = 0
P15: Reserved. Default = 100
P99: Reserved. Default = 99
d0: Reserved. Default = 14
Enable the Settings Mode: Pressing the Power + Mode
simultaneously will enter the Dashboard setting mode.
Short pressing the power button will toggle through the 10
available settings for the scooter
Toggling through
the Settings
Changing the
P Value
Once you have the P setting you wish to change, press the mode
button will increase value, the power button to decrease it
Setting the
Change
Holding the mode button will set the value & return you to the P
menu. Also, after 5 seconds the Dash will return to the main screen.
2
Dash: Dashboard Settings
To Next Page
Loading...
General