PC requirements for AutoLab systems
If PCs are to be purchased locally or supplied by the customer, the following is the minimum specification of PC required:
Intel(R) Celeron(R) processor 450 [2.2GHz, 512KB L2, 800MHz FSB]
2GB DDR3-800MHz SDRAM [1 DIMM]
17” colour monitor
40 GB Hard Drive
52X CD-R OM d r ive
Network card
Windows XP /SP3(must) , 32/64 bits
Windows 7 ( 32/64 Bits)
English PS/2 Keyboard
Mouse
1 RS232 Com ports required for PC for TF dispenser or SPS solution maker.
If fabric weigh scale is required to connect to TF dispenser PC, then this PC requires 2 RS232 COM ports, instead of 1.
No spare PCI or ISA slots required
PCs should also include network card/connectors and necessary cabling etc, to allow PCs to be networked together
Connection of dispensers and solution makers to PCs.
One PC controls each model of AutoLab TF dispenser.
An RS-232 cable running between the PC and TF dispenser is supplied with each system.
Standard length of cable is shown below:
Model Standard cable length
AutoLab TF all models 15 m
To Next Page
Loading...
Need help?
General