Spectro Calibration
Skip to:
Help Index
Calibrating to the White Tile
Spectro Connection
Connection failure
Usual Setting
Place Spectro on the calibration base, checking that the white tile is situated below the
Spectro-head, press the Spectro button on the top of the device. Wait for calibration
to be completed, and the application will auto-forward to next step.
Spectro Positioning Note: Using a proper height table and chair eases the patch
reading process. If you find your hand slipping forward on the Spectro your chair may
be too high (or your table too low). If the back of the Spectro seems too high or too
large, your chair may be too low (or your table too high).
The Purpose of This Step
This screen allows you to calibrate your Spectro, prior to taking measurements with it,
to ensure accuracy.
The Long Answer
Attach your Spectro to a USB port prior to launching this application, in order to have
it auto-connect. If the Spectro Calibration screen tells you it does not find a Spectro
attached to your computer, then please follow the directions in the
Spectro Connection
section below. If Calibration is successful, you will automatically be forwarded to the
Read Patches screen.
Calibrating to the White Tile
Place the Spectro on the white tile in the calibration base. Check that the Spectro is
To Next Page
Loading...