correctly located, and press the top of the Spectro, or hit the enter or return key on
the computer to trigger calibration. When the calibration process is complete, the
application will automatically move forward to the Read Patches screen. If calibration
fails, an error message will appear. Should this occur, please check your connections,
and attempt calibration again.
Spectro Connection
First check that the device is properly connected. Next go to the application’s
preferences in the menu bar…
and choose the device from the Sensor popdown list. If a Spectro is connected, but
does not register in the Sensor Information section (showing ???? instead) then toggle
from Spectro, to None, then back again to trigger another search for the Spectro.
If the device is successfully found on the USB tree, then its information will now
register in the Sensor Information section of the window. You are now connected, and
ready to calibrate the device.
To Next Page
Loading...