8
Checking and Adjusting Auto Focus
After you have set up the SpyderLENSCAL and your camera as instructed above, you are
ready to check and adjust your auto focus. Look through your camera’s viewfinder and
select the center auto focus point. Adjust your camera until the center auto focus point
is positioned over the small, concentric squares on the right edge of the SpyderLENSCAL
target next to the “0” on the ruler guide. Focus and capture an image. It is advisable to
use the self-timer or a cable release so you do not introduce any vibration during
capture. (Do not use live view to focus and capture the image of the target or use a
focus-and-recompose method)
To Next Page
Loading...
Need help?
General