To Next PageTo Next Page
Need help?Do you have a question about the DATACOM TEXTRON LANcat Series and is the answer not in the manual?
General| Brand | DATACOM TEXTRON |
|---|---|
| Model | LANcat Series |
| Category | Cable Tester |
| Language | English |
Covers basic instrument setup and default parameter checks.
Step-by-step instructions for performing an Autotest.
Explains how to review summary and detailed Autotest results.
Guides users on how to save Autotest results for later use.
Instructions for performing a Quick Check test.
Describes testing for pin-to-pin continuity and wiring errors.
Explains Near-End Crosstalk (NEXT) measurement and its importance.
Details the Power Sum NEXT test for high-speed network certification.
Describes the length measurement test and its capabilities.
Covers propagation delay and delay skew measurements for LANs.
Explains attenuation measurement, signal loss over cable length.
Covers impulse noise measurement and its impact on network performance.
Explains impedance measurement for cable type confirmation.
Procedures for printing and uploading single or multiple reports.
Guidance on selecting modules, test standards, and connecting segments.
Setting the minimum reflection level for anomaly detection.
Configuring the detection level for impulse noise spikes.
Calibrating the Nominal Velocity of Propagation for accurate length measurements.
Calibrating the remote unit to maintain measurement accuracy.
Calibrating performance modules for maximum measurement accuracy.
Calibrating impedance for optimal accuracy.
Steps to connect and start an Ethernet traffic test.
Interpreting the displayed traffic conditions and errors.
Performing a self-test to diagnose LANcat operational issues.
Specifies test limits for Category 3, 4, and 5 UTP testing.
Instructions for safely disassembling the performance module.
Steps for recalibrating the unit after cable replacement.
