Modulators
Modulators lets you configure the modulation routing and amount for Mopho’s
four general-purpose modulation slots.
Since each Mopho modulation source has a single destination, the four general
purpose modulators provide a way to send a mod source (such as a sequence or
LFO) to additional destinations, with a different amount. There are also
additional mod sources available here, such as Noise, allowing a wide variety of
possibilities.
To configure a general-purpose modulation slot, select Modulators and choose
the appropriate modulator: 1, 2, 3, or 4. Then use the Source, Destination, and
Amount parameters to route the modulation as desired.
Source—Selects a modulation source. See Modulation Sources on page 32 for
possible sources.
Amount: -127…+127—Sets the amount of modulation.
Destination—Selects a modulation destination. See Modulation Destinations on
page 33 for a list of possible destinations.
26
To Next Page
Loading...
