Page 5 of 12
OPTION 1: INSTALLING EWP
®
& FAN DIGITAL CONTROLLER
Part #8000 or Part #8020
NOTE: Wiring from EWP
®
kit will not be required however retain for hard
wiring the EWP
®
during bleeding.
1. The Digital Controller must be fitted inside the passenger compartment.
2. Connect the wiring harness to the Digital Controller and mount the Controller in an
appropriate position --- avoid mounting the controller where it may be
exposed to direct sunlight.
3. An additional screw is provided for mounting Digital Controller fuse holder where
necessary.
4. Mount ‘Remote Test Light’ in a location, which will be visible. The ‘Test Light’ may
be fitted by inserting it through a 4.6mm hole drilled in a plastic area of the
interior/dashboard or simply with adhesive tape.
5. For installation of the sensor in the position of the thermostat refer to the Digital
Controller instruction booklet.
6. Bleed the EWP
®
. Refer to SECTION 4: BLEEDING THE EWP
®
(Page 9). After
bleeding the EWP
®
continue with the installation process.
To Next Page
Loading...
Need help?
General
