4
2.3 Wiring
The wiring work must be performed by qualied electrical
professionals, otherwise it may cause electric shock or
damage to devices.
DANGER
The wiring work must be carried out strictly according to this
manual, otherwise it may cause electric shock or damage to
devices.
DANGER
All power supplies connected to the inverter must be cut off
and wait for not less than the time indicated on the inverter
before wiring work, otherwise it may cause electric shock.
DANGER
WARNING
Handle the device gently to prevent accidental fall off, which
may hurt the feet and break the inverter.
WARNING
Install the inverter in the place where there is no vibration, no
w a t e r d r o p l e t s a n d n o d i r e c t s u n l i g h t .
WARNING
If the inverters are to be installed in the cabinet, especially
two or more inverters in one cabinet, please pay attention to
the installation position, ensure good ventilation and heat
dissipation, otherwise it may cause device fault or damage.
WARNING
Do not drop the wire end, screws or drilling residue into the
inverter during the installation, otherwise it may damage the
device.
DANGER
Assemble and tighten the xing screws of the inverter
according to the regulations, otherwise the inverter may
accidently fall off and get damaged.
DANGER
It is not allowed to install the inverter in environment
containing explosive gas, otherwise it may cause explosion.
DANGER
It is not allowed to install the inverter in place accessible to
children and other public, otherwise it may cause electric
shock.
To Next Page
Loading...
Need help?
General
