5
Shielded cables must be used for encoders, sensors and other
suscep t i b l e co m p o n e n ts a n d r eliably g r o u nded.
WARNING
Cables, circuit breakers, contactors and other components
must be selected as required by the manual.
WARNING
Strictly follow the screen printing on the inverter during the
wiring and do not connect the input and the output inversely,
otherwise it can damage the device.
WARNING
2.4 Operation
Make sure all the wiring and connections are correct and the
case cover is close before powering on.
DANGER
Do not install compensation capacitors or surge suppressors
at the output of the inverter, otherwise it may cause overheat
and damage the inverter.
WARNING
Do not remove cover plate after powering on, otherwise it
may cause electric shock.
DANGER
Do not perform any operation other than the panel setting on
the inverter during running, otherwise it may cause electric
shock or damage the device.
DANGER
The inverter must be grounded reliably, otherwise it may
cause electric shock.
DANGER
The terminal signal cable of the inverter should be put away
from the power cable as far as possible. If the distance is not
enough, they should be cross-distributed vertically,
otherwise it will cause signal interference.
WARNING
Make sure all terminal screws are tightened while wiring,
otherwise it may damage the device.
WARNING
To Next Page
Loading...
Need help?
General
