EasyManuals Logo
Home>Daymak>Scooter>Monaco

Daymak Monaco User Manual

Daymak Monaco
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
Charging your E-Bike
Charging your e-bike is a simple process. You require the following:
•Thechargerthatcamewithyoure-bike.
•A110Vhouseholdelectricaloutlet.
Charger Warning
Only use the chargers that were supplied with your e-bike. Using chargers that do not
have specications identical to those which came with the e-bike could irreparably dam-
age your e-bike’s battery and electrical systems, and may cause injury.
To charge your e-bike, follow these steps:
1. Turn o the e-bike and remove the key from the ignition.
2. Plug the female end of the charger cable into the charging slot on the e-bike.
This is found on the outside casing of the e-bike, in front of and just underneath
the seat.
3. Plug the male end of the charger power cable into your wall socket. This should
be a110v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 110V current.
4. Allow the e-bike’s battery to charge for the appropriate amount of time (6-12
hours).
5. Disconnect the charger when the LED light on the charger is green. The batteries
have been fully charged.
If your chargers LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery or
charger may need replacing. Stop charging and bring both to your Daymak dealer imme-
diately. Do not charge the battery.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Daymak Monaco and is the answer not in the manual?

Daymak Monaco Specifications

General IconGeneral
BrandDaymak
ModelMonaco
CategoryScooter
LanguageEnglish

Related product manuals