11
Maximum Load
Do not exceed the maximum load capabilities of your scooter. You can nd the exact load-
ing capacity listed in the technical speci cations in this guide.
If you exceed the maximum load, the performance of the scooter will su er.
Exceeding the maximum load of your scooter could cause damage to the shocks, to the
mechanism and, ultimately, even to the frame. It could also cause your motor to work too
aggressively, and it may burn out.
Disconnecting the Circuit Breaker*
When the circuit breaker is disconnected, all power from the battery to the scooter is
blocked. This is useful if you are going to store your scooter or if it is damaged and you
wish to bring it to be serviced.
Disable the circuit breaker using the following very simple procedure.
1. Open the seat compartment.
2. Find the circuit breaker switch (it should be very obvious).
3. Activate the switch. The power to the scooter will be disabled.
Long-Term Storage of your Scooter
If you are storing your scooter for a long period, disconnect the circuit breaker. This is a saf-
er way to store the scooter, as it prevents accidental activation of the scooter and makes it
impossible to activate it even with the key. The circuit breaker is found by opening up the
battery case. It sits between the battery and the controller.
Please see the section titled “Your Battery” for instructions on battery maintenance while
your scooter is being stored.
*Your scooter may or may not have a circuit breaker. If it is not clearly visible in the seat compartment, it is likely that your bike does not
have a circuit breaker and thus this section does not apply.
To Next Page
Loading...
Need help?
General
