17
Accessing your circuit breaker
To prevent surges, we have installed a circuit break-
er. If you are unable to get power to your bike more
than likely your circuit breaker has been triggered
and needs to be switched to the on position.
To do this:
Unlock the seat compartment by turning the key
into position 3 (seen on previous page) then li the
seat up.
Once you look inside you will see this circuit break-
er pictured to the right. Make sure the switch is set
to ON. If not ip the switch to ON to turn on the
power.
**Please note with the circuit breaker o the alarm
system doesn’t work **
Display
Shows the speed in km/h on the top.
In the left corner is a battery symbol
that shows you how mcuh power you
have.
Besides that is the amount of Voltage
your bike has. The higher the number
the more power it has.
In the bottom right is your distance
travelled (odometer).
To Next Page
Loading...
