17
Accessing your circuit breaker
To prevent surges, we have installed a circuit break-
er. If you are unable to get power to your bike more
than likely your circuit breaker has been triggered
and needs to be switched to the on position.
To do this:
Unlock the seat compartment by turning the key
into position 3 (seen on previous page) then li the
seat up.
Once you look inside you will see this circuit break-
er pictured to the right. Make sure the switch is set
to ON. If not ip the switch to ON to turn on the
power.
**Please note with the circuit breaker o the alarm
system doesn’t work **
24V Battery Pack
Underneath the seat you will nd the 24V battery
pack. Li this out by the straps when the bike is
turned o and unplug the power cable to charge this
inside or store it .
Please note when charging this battery outside of
the pack it must be connected to the 60V battery
pack if using your 84V charger.
Removable Battery Packs
To Next Page
Loading...
