DB Audio Xtinct 15 - SERIES CONNECTION (2 Ohm); PARALLEL CONNECTION (Not recommended)

This will give you 0.5 Ohm impedance, only use this configuration if you are using 4 or
more KARNAGE Subwoofers. Or is your amplifier is capable of running less than
0.25Ohm in mono.
Series 2Ohm Impedance- recommended
Connect one side of the speaker terminal Positive to the Negative and use this
NEGATIVE connection to the Amplifier.
Connect one side of the speaker terminal Negative to the Positive and use this POSITIVE
connection to the Amplifier.
This configuration will give you 2Ohms. This is what we recommend if using one or two
woofers.
SERIES CONNECTION PARALLEL CONNECTION
Not recommended
Parallel:
Take both Positives from each Terminal
and connect to the Positive on the
Amplifier.
Take both Negatives from each Terminal
Series:
Take the Positive from one Terminal
To the Amplifier. Connect the Negative
to the same Terminal Positive.
Take the Negative from one Terminal
and connect it to the Negative on the
Amplifier.
To the Amplifier. Connect the Positive
To the Negative to the same Terminal.
2 Ohm 0.50 Ohm
08