dbx SNR 1 User Manual

Read, retain, and heed all safety and operating instructions and warnings provided.

Avoid water, ensure proper ventilation, use recommended carts/stands, and avoid heat sources.

Connect to correct power sources, protect cords, and ensure proper grounding for safety.

Clean only as recommended and ensure outdoor antennas are away from power lines.

Examine carton and contents for shipping damage; save packing materials for future use.

Check for hookup cables, warranty card, and mounting brackets included with the unit.

No special cooling needed; components can be stacked if they don't generate excessive heat.

Details on connecting blue (neutral) and brown (live) wires according to terminal markings.

Connect your preamp's Tape Output to these inputs for signal input.

Connect these outputs to your preamp's Tape In for signal output.

Connect tape recorder outputs to IN/PLAY inputs and outputs to OUT/REC for recording.

Connect the power cord to a power source; adjust voltage setting with caution if applicable.

Illustrates basic connection of SNR 1 between preamp and tape deck.

Shows advanced integration with multiple audio processors and components.

Ensure preamp's tape monitor is set to 'Tape' for signal return from the component.

Recommends chaining components in successive tape loops for complex systems.

Controls for unit power and setting the noise reduction sensitivity threshold.

Buttons to select noise reduction timing and bypass the processing effect.

Choose between listening to external sources or the tape deck playback.

LED indicators for signal level relative to threshold and effective frequency range.

Initial setup steps including setting preamp tape monitor and input selector.

Instructions for playing back tapes using the SNR 1, adjusting threshold level.

Guidance for making recordings with the SNR 1, setting source and pre-post modes.