USER MANUAL - STEAM IRON
can be extracted from the base.
5 will be lled with water into the base and force it to lock, the water tank is locked when there is
a clear lock sound
Dry iron
1 Connect the rated power supply, long press the iron control button or long press the base control
button to enter the working state
2 After heating the product, ironing can be performed
3 Do not press the steam switch button when it is dry
steam iron:
1 Fill the tank with water
2 Long press the pressing button of the iron or the base control button, and the product will be
heated. When the indicator light on the control button of the heating iron is long lit, the product
will be heated.
3 After starting the product, the default is small steam. It is recommended to release small steam
for 2min before entering large steam.
4 Select the appropriate steam size for each fabric, press the steam switch (20S) and steam will
release from the bottom plate
5 Please lock the steam button when steam ironing is needed for a long time. Manual control is
recommended when steam ironing is needed for a short time
selfclean
1 Long press the (2s) iron control button and the iron steam switch to automatically enter the
cleaning state. The cleaning indicator lights up
2 Make sure there is enough water in the tank when using the cleaning function
3 Press the steam button and the pump will work at full frequency. Clean the bottom plate of the
iron. Release the steam switch and the pump will stop working
4 Once again long press the (2s) iron control button and the iron steam switch to switch back to
low steam
Auto shut off:
1 The product automatically enters the power off state after working for ten minutes
2 When the product enters the state of power failure, the buzzer will give six short sounds and the
automatic power failure indicator will ash
3 Press the control button on the iron or the iron steam switch or the control button on the base
and press any one of the keys to return to working condition.
Tip water shortage
1 Under the working condition of steam, when no steam is released from the bottom plate for
about 1min, the product will automatically enter the state of water shortage
2 After the product enters the state of water shortage, the water shortage indicator is long bright
and the water pump stops working
3 Add the water in the water tank to the maximum position according to the water requirements,
and lock the water tank, release the steam switch of the iron and press the steam switch to restore
the working state
Cleaning and collection
Do not start cleaning the iron until it has cooled completely
To Next Page
Loading...