DCG VERI50 - Page 15

dcg16.it
Instruction manualInstruction manual
15
EN
- FAN SPEED
Press SPEED button on the Control Panel or the remote control to adjust wind speeds
to low (1), medium (2), high (3), speed lights (1,2,3) indicates selected current wind speed.
The wind speeds change on rotating basis.
- ANION
Press ANION button on the control panel or the remote control. To turn on ANION
mode, press button again. The system will stop ANION function. (ANION is used for
air purier)
- COOL
Enter the COOL mode by pressing COOL button on the control panel or the remote
control. To turn off the COOL mode, press COOL button again. The system will
automatically exit the COOL mode.
REMARKS: When the COOL mode is activated, the pump inside the water tank will pump
water to saturate the cooling pad. Heat that ows through the cooling pad will exchange
with the water and cool the air owing through the cooling pad to lower the temperature.
Therefore, a decrease in temperature depends on relative humidity and air temperature
when the unit is in COOL mode. In the case where the fan speed is high, when the icon is
pressed, the fan will drop to the lowest speed for 30 seconds before resuming the speed
previously set.
- HEAT
Press HEAT button on the control panel or the remote control to turn on HEAT mode,
press HEAT button again, the system will stop HEAT function. While operating the
HEAT mode, the wind speed is adjustable from low (1) - medium (2) - high (3) normally.
If the humidity is required during the HEAT mode, Press COOL button to reduce
the dryness. After turn off the unit while the HEAT mode is activated, the fan keeps
functioning for 1 minute for heat release purpose.