Dcm MC-HD200 - IR Remote Controller Explanation

To Next Page

To Previous Page

IR Remote Controller Explanation

0. Standby Button

Press this button to enter standby mode. Press it again

to enter normal mode.

(Note: Power consumption in standby mode is

approximately half of the normal mode)

1. Position Buttons

To set preset or call preset

2. * Button

3. Set/Clear Preset Buttons

Set preset: Store a preset position

[SET PRESET] + Numeric button (0-9):Setting a

corresponding numeric key preset position

Clear preset: Erase a preset position

[CLEAR PRESET] + Numeric button (0-9)

Or: [*]+[#]+[CLEAR PRESET]: Erase all the preset

Or: [#]+[#]+[#]: Erase all the preset

4. BLC (Backlight Compensation) Button

BLC ON/OFF: Press this button to enable the

backlight compensation. Press it again to disable the

backlight compensation.(NOTE: Effective only in

auto exposure mode)

Notice: If a light behind the subject, the subject will