16
INSTALLATION
Power Supply installation (for BE1 products only)
Your BE1 product comes supplied with a power supply for ignition and internal lighting,
which is concealed in a box with an attached power supply cord. It is recommended that
the power supply is mounted to the rear panel of the CAD1 cart using the 4 holes provided.
HZ VOLTAGE AMPS
50 Hz 230V 10A
IMPORTANT!
Use only a Residual Current Device (RCD) protected circuit with this power supply.
The suggested location for installation is above the hole the power supply cord routes
through, which is on the inside of the right-hand side of the cart’s back panel. Use four nuts
and bolts to attach the power supply to the cart.
Routing the power supply cord
Route the cord through the provided hole and
connect to the nearest 230V 10A RCD (Residual
Current Device) protected electrical outlet.
To Next Page
Loading...