Why didn't my dishes dry in my DCS Dishwasher?
If your DCS Dishwasher isn't drying dishes properly, make sure the dishes aren't nesting together. Refill the rinse agent dispenser if it's depleted, or increase the rinse agent setting if it's too low. If you used the Eco wash program, try choosing a standard wash program instead.
What to do if my DCS DishDrawer DD24 Dishwasher is leaking water?
If your DCS Dishwasher is leaking water, check the following: Ensure the drain hose is securely reconnected to the waste pipe and the water inlet hose is properly connected. If the leaks persist, turn off the water and power supplies to the DishDrawer® and contact your dealer or Authorized Service Center.
Why are dishes not drying in my DCS DishDrawer DD24?
If dishes are not drying in your DCS Dishwasher, make sure the dishes are not nesting together and ensure that you've refilled the rinse agent dispenser, increasing the rinse agent setting if it's too low. Also, avoid using the Eco wash program; instead, choose a standard wash program.
Why is my DCS Dishwasher foaming?
If your DCS Dishwasher is foaming, it could be due to using an incorrect amount of detergent. Check the 'Wash programs and detergent quantities' section or follow the detergent manufacturer’s instructions. Too much egg in the wash load can also cause foaming, so increase the amount of detergent. Additionally, a rinse agent setting that's too high can cause foaming, so decrease the rinse agent setting.
How to remove water marks from dishes in my DCS DishDrawer DD24 Dishwasher?
If you notice water marks on dishes from your DCS Dishwasher, try refilling the rinse agent dispenser or increasing the rinse agent setting. Also, make sure the DishDrawer® isn't overloaded or incorrectly loaded.
Why is my DCS DishDrawer DD24 beeping intermittently?
If your DCS Dishwasher is beeping intermittently, it indicates that the DishDrawer® is in pause mode. Close the DishDrawer® and press the button to resume.
Why is my DCS DishDrawer DD24 Dishwasher not dispensing detergent?
If your DCS Dishwasher did not dispense detergent, it may be because the detergent dispenser was wet when loaded. Clean the dispenser and ensure it is dry when adding detergent.
What happens if my DCS DishDrawer DD24 Dishwasher has a power failure?
If your DCS Dishwasher experiences a power failure, wait until power resumes. The cycle will restart in the same part of the wash program.
How to prevent water marks on dishes from my DCS DishDrawer DD24?
If your DCS Dishwasher leaves water marks on dishes, the rinse agent may be depleted; refill the rinse agent dispenser. Alternatively, the rinse agent setting might be too low, so increase it. Also, ensure that the DishDrawer® is not overloaded or incorrectly loaded, consulting the section on loading for proper techniques.
What to do if my DCS DishDrawer DD24 Dishwasher won't start?
If your DCS Dishwasher is not starting, check the following: ensure the power supply is connected, the drawer is firmly closed, and that neither the Keylock nor Childlock feature is activated (deactivate by holding down the button until the light disappears). Also, verify that the button is pressed and that the drain hoses are not bent or kinked. If the filter plate or drain filter is blocked, refer to the ‘User maintenance instructions’ section.
Essential precautions for safe operation, installation, and general use of the appliance.
Details on proper installation, securing the appliance, and electrical grounding requirements.
Precautions for cleaning, operation, and avoiding hazards during use.
Explains the functions of the Power, Start/Pause, Delay Start, and Lock buttons.
How to activate lock features, select wash programs, and use the ECO option.
Identifies controls, indicators, and symbols on the LCD control panel.
How to use lock features, select programs, and understand progress symbols.
Step-by-step instructions for loading dishes and starting a wash cycle.
Guidance for different materials and preparing for periods of non-use.
Proper loading of cutlery and small items in the basket and container.
Tips for container placement and using the dishwasher tablet tray.
Features for supporting glassware and adjusting tine configurations.
How to adjust rack height, use the knife clip, and fold tines.
Ensure proper water circulation by correct item placement for effective washing.
Examples of incorrect loading that hinder wash performance and may cause issues.
How water hardness affects performance and methods to mitigate issues.
Overview of wash programs and recommended detergent amounts based on water hardness.
Instructions on how to fill the pre-wash and main wash compartments and use the dispenser.
How to refill, adjust settings, and understand the rinse agent indicator light.
How to adjust rinse agent, auto power, end-of-wash beeps, and closed drawer options.
Steps to enter adjustment mode, change settings, and save them for models without LCD.
How to enter adjustment mode, scroll through options, and save changes on LCD models.
Guidelines for cleaning exterior surfaces, controls, and the drain filter.
Instructions for removing and cleaning the spray arm and filter plate.
How to correctly reassemble the filter plate and spray arm after cleaning.
Possible causes and solutions for common issues like unclean dishes, foaming, and water leaks.
Addresses issues like beeping, starting problems, water marks, and dishes not drying.
How to identify fault codes displayed on the panel and initial steps to resolve them.
Details of fault codes F1 through F9, their potential causes, and recommended actions.
Details of fault codes U1 and U4, their potential causes, and recommended actions.
Steps to verify before calling for service and where to find further assistance.
Information on wash times and temperatures for different wash programs.
Details on test parameters, detergent quantities, and recommended loading for testing.
Essential precautions for safe operation, installation, and general use of the appliance.
Details on proper installation, securing the appliance, and electrical grounding requirements.
Precautions for cleaning, operation, and avoiding hazards during use.
Explains the functions of the Power, Start/Pause, Delay Start, and Lock buttons.
How to activate lock features, select wash programs, and use the ECO option.
Identifies controls, indicators, and symbols on the LCD control panel.
How to use lock features, select programs, and understand progress symbols.
Step-by-step instructions for loading dishes and starting a wash cycle.
Guidance for different materials and preparing for periods of non-use.
Proper loading of cutlery and small items in the basket and container.
Tips for container placement and using the dishwasher tablet tray.
Features for supporting glassware and adjusting tine configurations.
How to adjust rack height, use the knife clip, and fold tines.
Ensure proper water circulation by correct item placement for effective washing.
Examples of incorrect loading that hinder wash performance and may cause issues.
How water hardness affects performance and methods to mitigate issues.
Overview of wash programs and recommended detergent amounts based on water hardness.
Instructions on how to fill the pre-wash and main wash compartments and use the dispenser.
How to refill, adjust settings, and understand the rinse agent indicator light.
How to adjust rinse agent, auto power, end-of-wash beeps, and closed drawer options.
Steps to enter adjustment mode, change settings, and save them for models without LCD.
How to enter adjustment mode, scroll through options, and save changes on LCD models.
Guidelines for cleaning exterior surfaces, controls, and the drain filter.
Instructions for removing and cleaning the spray arm and filter plate.
How to correctly reassemble the filter plate and spray arm after cleaning.
Possible causes and solutions for common issues like unclean dishes, foaming, and water leaks.
Addresses issues like beeping, starting problems, water marks, and dishes not drying.
How to identify fault codes displayed on the panel and initial steps to resolve them.
Details of fault codes F1 through F9, their potential causes, and recommended actions.
Details of fault codes U1 and U4, their potential causes, and recommended actions.
Steps to verify before calling for service and where to find further assistance.
Information on wash times and temperatures for different wash programs.
Details on test parameters, detergent quantities, and recommended loading for testing.
General| Product Type | Dish Drawer |
|---|---|
| Installation | Built-In |
| Energy Star Rated | Yes |
| Energy Star Certified | Yes |
| Model Series | DD24 |
| Number of Drawers | 2 |
| Place Settings | 8 per drawer |
| Wash Cycles | Normal, Heavy, Rinse, Eco |
| Control Type | Electronic |
| Cycles | Delicate, Normal, Heavy, Fast, Rinse, Eco |
| Color Options | Stainless Steel |
To Next Page
