DDS Double - Features of the DDS DOUBLE

8
8 9
How to Wear How to Wear
5
7
6
8
9
Skip the next curved opening
and continue to thread the belt
through the fth and nal slot.
The fully attached Posterior Panel and Belt should look like the following
Wrap the device around the abdomen with the DDS logo in the center and
upright position, attaching rst the Top Velcro Enclosure. Immediately
proceed to tighten the Bottom Velcro Enclosure.
Attach the Anterior (front)
Panel to the white Supplemental
Velcro Patch located behind the
top Velcro Enclosure.
Connect the Hand Air Pump to the
Air Valve. Make sure to connect
the air injection tongs exactly with
the air valve.
Proceed to use the Hand Air Pump to inate the belt until the gauge reaches the
green-orange area (10-14 psi) on the Hand Air Pump indicator.
Important : The device should be close-tting, secure and comfortable.
The Belt should rest precisely between your hip/pelvic bone and your ribcage.
Removing DDS: You MUST release the air completely out of the device before removal.
You can do so by unscrewing the Air Valve.
Warning:
Do not exceed pumping to the red area.