™
Akagi: Step by Step
201
Pack 7
Tools and materials
Wet and dry paper
Sandpaper
Glue
Superglue
Putty
Tweezers
Needle le
Knife
Double-sided tape
Masking tape
Metal primer
Paint brush
Gray paint
Matte black paint
White paint
Cardboard
Stick
Wood primer
Pencil
Making the side walls of the hangar tray: Step 1
Test-tting the tray: Step 2
1
2
Position the two grooved walls
as shown, using the lines
highlighted by the blue arrows
as a reference, and glue the
shorter square rods into place on
the grooves, aligning the back
edges of the two.
Test-t the hangar tray in place
as shown, between the central
and stern elevators. Align the
bow end with the stern side of
the central elevator and the aft
end with the bow side of the
stern elevator, making sure there
is a gap of 2 mm between the
outer edge and the wall of the
hangar. Make any adjustments
necessary to achieve the t.
Your parts
Hangar tray (oor)
Hangar tray (side wall) × 2
Square rod (long) × 10
Square rod (short) × 31
Door × 6
20-cm gun body × 2
20-cm gun barrel × 2
The 20-cm guns and stern hangar tray
To Next Page
Need help?
General
