R
124 RR
Operating instructions and warnings
17
Instructions Function
Display
The control board is ready to receive instructions
Deletion of all transmitters
Scroll down the parameters until you visualize P004
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Done! The transmitters memory has been deleted
Scroll down the parameters until you visualize “----”. The control board awaits
further instructions
Memorization of transmitters
1
Scroll down the parameters until you visualize P005
Confirm! The receiver enters in memorization mode
The flashing light turns on
Press on any key of the transmitter.
Memorization done! The flashing light goes out for 2 seconds. The display
visualizes the number of the transmitter just memorized (es. “r001”)
The receiver reverts automatically to memorization mode
The flashing light turns on again
Memorize all necessary transmitters
Wait 10 seconds before quitting the memorization mode
The receiver will now receive all the memorized transmitters
How to activate the memorization mode without
Operating on the control board
1
Press simultaneously on key CH1 and CH2, or on the hidden key of a
transmitter already memorized
How to search and delete a transmitter
Scroll down the parameters until you visualize P006
Confirm! You can now select the transmitter
Scroll down the transmitter numbers until you reach the tran-
smitter to be deleted (eg. “r003”)
Confirm the deletion by pressing the OK key for a few seconds
OK! The transmitter is deleted
You can now select the parameter
Scroll down the parameters until you visualize “----”. The control
board awaits further instructions
1
Make sure that the receiver is set to receive the type of coding of the transmitter you wish to memorize: visualize and, if
necessary, update parameter n° 8 “type of coding” (see “8.4 Personalization of working parameters “)
To Next Page
Loading...